Touch Record - Studer D950 Operating Instructions Manual

D950/Vista7 Digital Mixing System
5.7.2

Touch Record

D950:
Touch Record:
5-64 AutoTouch+
With TOUCH RECORD engaged, touching a Write or Trim enabled control
will change it from ENABLE to RECORD. This will effectively perform a
"Punch-In" for that control. Touching a control in READ will change it to
AUDITION.
When released, a control in RECORD will change back to ENABLE, ef-
fectively "Punching-Out" (if TOUCH HOLD is not engaged). Subsequent
Touch/Un-touch events will to toggle that control in an out of RECORD.
Likewise a control in AUDITION will revert to READ when released.
To sum it up, if TOUCH RECORD is used alone (without TOUCH HOLD)
controls will change to either RECORD or AUDITION for the duration of
the human contact with the control.
With only TOUCH RECORD engaged (without TOUCH HOLD), Touch/Un-
touch events perform the following functions when dynamic controls are in
the Control Modes indicated:
• READ: Touch/Un-touch will toggle the control in and out of
AUDITION.
• WRITE ENABLE: Touch/Un-touch will toggle the control in and out of
RECORD. The control will change from WRITE ENABLE to WRITE
RECORD when touched and will snap back to recorded values (WRITE
ENABLE) when released. The control will glide back if GLIDE is en-
gaged.
• TRIM ENABLE: Touch/Un-touch will toggle the control in and out of
RECORD. The control will change from TRIM ENABLE to TRIM
RECORD when touched and will snap back to recorded Trim values
(TRIM ENABLE) when released. The control will glide back if GLIDE
is engaged.
• ISOLATE: Touch/Un-touch events of Isolated controls are not recog-
nized by AutoTouch+.
The examples above assume that WRITE TO PUNCH OUT is active. Refer to
Note:
chapter 5.9.1.
SW V3.3
Vista:
Date printed: 27.08.03