D19Devicestemplate.ini - Studer D950 Operating Instructions Manual

D950 Digital Mixing System
6.9

d19devicesTemplate.ini

Comment=D950D19DeviceResourcesSpecifications for SW Release V2.03
Comment=03.11.98 by JM
; [PHYSICAL_DEV]
; NumberOfCtrlInterface=corresponds to COM ports assigned to D19 Devices in D950System.ini.
; NumberOfMICAD=
; NumberOfMP4RC=
; Note: If NumberOfCtrlInterface=1, NumberOfMICAD or NumberOfMP4RC must be in the range between
; 0 and 16 for MicADs and between 0 and 15 for MP4RCs.
; NumberOfMICAD resp. NumberOfMP4RC can be smaller than defined below ([MICAD_x] resp [MP4RC_x),
; but not greater. MicAds & MP4RC have to be connected separate control interfaces.
[PHYSICAL_DEV]
NumberOfCtrlInterface=2
NumberOfMICAD=6
NumberOfMP4RC=2
; [MICAD_x]
; CtrlInterface=
; CtrlChannel=
; LinePresent=
; MCHDigitalOutPresent= indicates, if ADAT output is present (Yes/No)
[MICAD_0]
CtrlInterface=1
CtrlChannel=1
LinePresent=Yes
MCHDigitalOutPresent=Yes
[MICAD_1]
CtrlInterface=1
CtrlChannel=2
LinePresent=Yes
MCHDigitalOutPresent=Yes
[MICAD_2]
CtrlInterface=1
CtrlChannel=3
LinePresent=Yes
MCHDigitalOutPresent=Yes
[MICAD_3]
CtrlInterface=1
CtrlChannel=4
LinePresent=Yes
MCHDigitalOutPresent=Yes
[MICAD_4]
CtrlInterface=1
CtrlChannel=5
LinePresent=Yes
MCHDigitalOutPresent=Yes
[MICAD_5]
CtrlInterface=1
CtrlChannel=6
LinePresent=Yes
MCHDigitalOutPresent=Yes
6-34 System Administration
actual D19 resources
corresponds to MicAD resp. MicAD STAGE devices actually present
corresponds to D19 Stagebox 4 Ch. Preamp Cards (MP4RC) actually present
first MicAD with logical Micad device No. (starting with 0)
connected to control interface x (1..NumberOfCtrlInterface)
corresponds to CTRL CH selected on the MicADs frontpanel (1..16)
indicates, if Line Interface is present (Yes/No)
SW V3.3 Date printed: 05.12.03