Snapshot; Parameters - Studer OnAir 3000 Operating Instructions Manual

OnAir Digital Mixing Consoles
6.5.26

Snapshot

6.5.26.1

Parameters

Snapshot Location - Local
Snapshot Location
InitialSnapshot: Loading Input Fader Gain
InitialSnapshot: Loading REC PF
InitialSnapshot: AutoSave Desk Settings
6-64 Configuration
On this page either the parameters required for Local snapshot operation, or
the ones needed for accessing a central snapshot file server (Remote) can
be configured.
Selects the location of the snapshots displayed in the user GUI; either Local,
i.e., in the console memory, or Remote (in case of a central snapshot server).
The parameters listed below are displayed in case of Local only.
If set Off, the initial snapshot does not contain the input fader values; i.e.
when powering the console on, the input fader values (or fader positions in
case of optional motor faders) remain as they are. If set On, the input fader
values/positions are saved with the initial snapshot and become updated with
the saved values when the console is powered on. Default: Off.
If set Off, the initial snapshot does not recall the channels REC PF bus
assign state; i.e. when powering the console on, the REC PF bus assignment
is always Off. If set On, the channels REC PF bus assign states are recalled
by the initial snapshot and become updated with the saved values when the
console is powered on. Default: Off.
If set On, the initial snapshot is automatically updated in intervals of 10 s
max., in order to memorize the current desk settings in case of powering the
console off (or a power outage). Default: Off.
Note: AutoSave must be switched Off whenever initial snapshot files are moved
or copied manually.
SW V6.0 Document generated: 10.10.14