Monitoring Source Selector Keys; Talkback Destination Keys; Rotary Assignment Function Keys; N-X Mode - Studer OnAir 3000 Operating Instructions Manual

7.4.7

Monitoring source selector keys

7.4.8

Talkback Destination keys

7.4.9

Rotary Assignment function keys

7.4.10 n–X Mode
Document generated: 10.10.14
Configuration Tool: Desk Common → Keys
The monitoring sources selectable either on the monitoring/talkback module
or within the monitoring page of the User GUI are configured here for each
location (CR, ST1...3).
Note: Only signals related to the corresponding desk should be defined for a certain
location; e.g. AUX1 must not be added to the MonSrc ST1 list if it is not used
on the secondary desk.
Configuration Tool: Desk Common → Keys
Talkback destinations, selectable on the monitoring/talkback module or within
the TB SP page of the User GUI, are configured here for each location (CR,
ST1..3).
Note:
Only talkback destinations related to the corresponding desk should be defined
for a certain location; e.g. TB to PGM A must not be added to the TB ST1 list
if PGM A is not used on the secondary desk.
Configuration Tool: Desk Primary Desk → Fader Assign → Group X
Configuration Tool: Desk Primary Desk → Rotary Assign → Group Y
Configures the rotary assignment function keys for the fader and rotary assign-
ment modules, considering the desk resource definition.
Note:
Only rotary functions related to the corresponding desk should be added to
the list; e.g. Aux1 must not be added to the list if AUX1 is not used on the
secondary desk.
The labels of the rotary function may be changed as well; e.g. the AUX4
rotary function may appear as AUX1 on the secondary desk.
Configuration Tool: Config → Masters
Since the secondary desk normally uses PGM B, the default initialization of
the N–X mode must be changed to PGM B for all N–X buses that are assigned
to the secondary desk.
SW V6.0
OnAir 3000 Digital Mixing Console
A/B Desk Configuration 7-13