Insert Page - Studer OnAir 3000 Operating Instructions Manual

OnAir 3000 Digital Mixing Console
Lock, Unlock
5.3.5.3

insert Page

5-54 Operation
Connect When touching Connect, a list appears for output type selection. After selec-
tion from the list, the blue bullet at the crosspoint indicates the selected type:
Input (or master output, or patch group output)
DIR Out PP (pre-processing)*
DIR Out AP (after processing)*
CHAN Out (after fader)*
This selection list does not show up, of course, for master and patch group
outputs.
Clear Clears the connection at the cross point of the vertical (master or input) and
horizontal (output) cursor lines.
A connection may be protected from changes by selecting it and touching the
Lock button. If locked, the Connect and Clear buttons are blanked, and a
padlock symbol is indicated next to the output label.
To unlock, select the connection and touch the Unlock button.
* Since the direct and channel output tap points are located within or after the
channel processing, they can deliver an audio signal only if the corresponding
input is assigned to a fader.
It is also possible to route the de-embedded output signal of an SDI input
card via the D21m frame's backplane to the input of a Dolby
for decoding multichannel surround signals; this is done in the output routing
page.
There is a pool of eight inserts. On the insert routing page they can be assigned
to the possible insert points (mono/stereo input channels and main master
buses) of the console.
The insert can be switched on or off either here with the ON button, on the
CHAN - FDR/Bus page of the channel, or on the Sum - Master page of the
master to which the insert is assigned. This means that, if an insert is assigned
to a channel, the insert on/off button is displayed on the corresponding chan-
nel or bus page. An insert symbol is displayed in the corresponding channel
field on the channel screen as well.
SW V6.0
E input card
®
Document generated: 10.10.14