Auto-Execute Command - Huawei Quidway S3900 series Command Manual

Hide thumbs Also See for Quidway S3900 series:
Table of Contents

Advertisement

Command Manual – Login
Quidway S3900 Series Ethernet Switches-Release 1510
Note:
To improve security and avoid malicious attack to the unused SOCKETs, TCP 23 and
TCP 22 ports for Telnet and SSH services respectively will be enabled or disabled after
corresponding configurations.
If the authentication mode is none, TCP 23 will be enabled, and TCP 22 will be
disabled.
If the authentication mode is password, and the corresponding password has been
set, TCP 23 will be enabled, and TCP 22 will be disabled.
If the authentication mode is scheme, there are three scenarios: when the
supported protocol is specified as telnet, TCP 23 will be enabled; when the
supported protocol is specified as ssh, TCP 22 will be enabled; when the supported
protocol is specified as all, both the TCP 23 and TCP 22 port will be enabled.
Example
# Configure to authenticate users using the local password on the AUX interface.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] user-interface aux 0
[Quidway-ui-aux0] authentication-mode password

1.1.2 auto-execute command

Syntax
auto-execute command text
undo auto-execute command
View
User interface view
Parameter
text: Command to be executed automatically.
Description
Use the auto-execute command command to set the command that is executed
automatically after a user logs in.
Use the undo auto-execute command command to disable the specified command
from being automatically executed.
Normally, the telnet command is specified to be executed automatically to enable the
user to Telnet to a specific network device automatically.
Huawei Technologies Proprietary
1-2
Chapter 1 Login Commands

Hide quick links:

Advertisement

Chapters

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Quidway S3900 series and is the answer not in the manual?

Table of Contents

Save PDF