Vrrp Mode - Dell Z9500 Command Reference Manual

TRACE-LIST Mode
To configure a Trace list, use TRACE-LIST mode.
To enter TRACE-LIST mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the ip trace-list command. Include the name of the Trace list. The prompt changes to
include (conf-trace-acl).
You can exit this mode by using the exit command.
VLT DOMAIN Mode
To enable and configure the VLT domain protocol, use VLT DOMAIN mode. For more information, refer
to Virtual Link Trunking
To enter VLT DOMAIN mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the vlt domaincommand then the VLT domain number. The prompt changes to include
(conf-vlt-domain).
You can return to CONFIGURATION mode by entering the exit command.

VRRP Mode

To enable and configure Virtual Router Redundancy Protocol (VRRP), use VRRP mode. For more
information, refer to Virtual Router Redundancy Protocol
To enter VRRP mode:
1. To enable VRRP globally, verify that you are logged in to CONFIGURATION mode.
2. Enter the vrrp-group command then enter the VRRP group ID. The prompt changes to include
(conf-if-interface-type-slot/port-vrid-vrrp-group-id).
60
(VLT).
(VRRP).
CLI Basics