Table of Contents
Advertisement
4
Installing the Remote Gateway 911x unit
To install the Remote Gateway 911x unit on a desk, attach the rubber feet to the
bottom and continue with
unit to the network" on page
wall, refer to the Remote Gateway 911x Series Installation and Administration
Guide (555-8421-220).
Connecting the Avaya Remote Gateway 911x series unit to
the network
To route calls over the IP network, or administer the Avaya Remote Gateway
911x series unit from another location on the IP network, connect the unit to the
Ethernet network by doing the following:
1
2
To connect the Remote Gateway 911x series unit to the analog line:
1
2
Close and latch the ferrite bead.
Note: You may need to adjust the cable loops to make them as tight as
possible.
Plug one end of a 10BaseT Ethernet cable (with an RJ-45 connector) to the
ETHERNET jack on the Remote Gateway 911x series unit.
Note: You must supply your own 10BaseT Ethernet cable with RJ-45
connectors. Contact your system administrator for the correct cable.
Plug the other end of the 10BaseT Ethernet cable to either an Ethernet hub or
network router.
Plug the RJ-11 cable into the 911x unit LINE connector.
Plug the other end of the cable into the analog line jack.
Avaya Remote GatewayInstallation
"Connecting the Avaya Remote Gateway 911x series
7. To install the Remote Gateway 911x unit on the
Avaya Remote Gateway 911x Series Quick Start Guide
7
Advertisement
Table of Contents
