Table of Contents
Advertisement
9. Log In to the Command Line Interface (CLI)
If you are using one of the
terminal emulation software package to establish a
session with the switch. Configure your terminal
emulation software parameters as follows:
• 9600 baud
• 8 data bits
• 1 stop bit
• no parity
• no hardware flow control (Windows 95 or later)
After the system has booted, the Login prompt is
displayed:
Welcome to the Alcatel Omni Switch/Router!
Version x.x.x.x
login :
Initially, there are three types of login accounts avail-
able on the Omni Switch/Router:
The
and
accounts allow full access to all
admin
diag
functions. The
account additionally supports a set
diag
of switching module tests (see the "Running Hardware
Diagnostics" chapter in your Omni Switch/Router User
Manual for details). The
privileges. All three accounts use
password.
serial ports, use a
MPX's
,
and
admin
diag
account allows read-only
user
as the default
switch
If you have Administrative (WRITE)
privileges on the switch, you can
create or delete logins and new user
accounts with administrative privi-
leges.
Partition Management allows you to
restrict access to particular switch
features on a per user basis. See the
"Switch Security" chapter in your
Omni Switch/Router User Manual for
details.
The following procedure uses the
as an example. Complete the following steps to log in
to the switch.
If the system displays the following
.
user
prompt:
Please Standby, chassis configuration changing
(Hit ^C to abort)...
it means you are attempting to access
the switch before it has completed
initialization or processing a previous
command. Wait until the switch
displays the login prompt before
entering any commands.
o Important Note o
o Partition Management o
admin
o Caution o
Installing Your Switch 9
login account
Advertisement
Table of Contents
