Qos-Policy-Output - Dell S4810 Reference Manual

qos-policy-output

Create a QoS output policy.
S4810
Syntax
qos-policy-output qos-policy-name
To remove an existing output QoS policy, use the no qos-policy-output qos-
policy-name command.
Parameters
qos-policy-
name
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.2.1.0
Version 7.6.1.0
pre-Version
6.1.1.1
Usage
Use this command to specify the name of the output QoS policy. Once output
Information
policy is specified, rate-shape, scheduler strict, bandwidth-percentage, and WRED
can be defined. This command enables the qos-policy-output configuration mode
—(conf-qos-policy-out).
When rate-shape in QoS policy is applied both on queue level and aggregate
mode, the queue-based shaping occurs first followed by the aggregate rate
shaping.
Related
bandwidth-percentage
Commands
wred
Quality of Service (QoS)
Enter your output QoS policy name in character format (32
characters maximum).
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Policy name character limit increased from 16 to 32.
Introduced on the C-Series and S-Series.
Introduced on the E-Series.
— assigns weight to the class/queue.
— assigns yellow or green drop precedence.
1361