Neighbor - Dell S4810 Reference Manual

Version 7.6.1.0
pre-Version
6.2.1.1
Usage RIP supports a maximum of 16 ECMP paths.
Information

neighbor

Define a neighbor router with which to exchange RIP information.
S4810
Syntax
neighbor ip-address
To delete a neighbor setting, use the no neighbor ip-address command.
Parameters
ip-address
Defaults Not configured.
Command ROUTER RIP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
pre-Version
6.2.1.1
Usage
When a neighbor router is identified, unicast data exchanges occur. Multiple
Information
neighbor routers are possible.
1400
Introduced on the C-Series.
Introduced on the E-Series.
Enter the IP address, in dotted decimal format, of a router
with which to exchange information.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Routing Information Protocol (RIP)