Show Config - Dell S4810 Reference Manual

Related
network
Commands
exit

show config

Display the changes you made to the RIP configuration. The default values are not shown.
S4810
Syntax
show config
Command ROUTER RIP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
pre-Version
6.2.1.1
Example
Dell(conf-router_rip)#show config
!
router rip
Dell(conf-router_rip)#
Routing Information Protocol (RIP)
— enables RIP.
— returns to CONFIGURATION mode.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
network 172.31.0.0
passive-interface GigabitEthernet 0/1
1409