Dell S4810 Reference Manual page 1385

Parameters
wred-profile-
name
Defaults The five pre-defined WRED profiles. When you configure a new profile, the
minimum and maximum threshold defaults to predefined wred_ge_g values.
If green profile is applied, default yellow also take effect and vice-versa.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
pre-Version
6.1.1.1
Usage Use the default pre-defined profiles or configure your own profile. You cannot
Information delete the pre-defined profiles or their default values. This command enables
WRED configuration mode —(conf-wred).
Related threshold
Commands profile.
Quality of Service (QoS)
Enter your WRED profile name in character format (16
character maximum). Or use one of the pre-defined WRED
profile names. You can configure up to 26 WRED profiles
plus the five pre-defined profiles, for a total of 31 WRED
profiles.
Pre-defined Profiles: wred_drop, wred-ge_y, wred_ge_g,
wred_teng_y, wred_teng_g.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series
— specifies the minimum and maximum threshold values of the WRED
1385