Service-Policy Output - Dell S4810 Reference Manual

Related policy-map-input
Commands

service-policy output

Apply an output policy map to the selected interface.
S4810
Syntax
service-policy output policy-map-name
To remove the output policy map from the interface, use the no service-
policy output policy-map-name command.
Parameters
policy-map-
name
Defaults none
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Usage A single policy-map can be attached to one or more interfaces to specify the
Information service-policy for those interfaces. A policy map attached to an interface can be
modified.
Related
policy-map-output
Commands
Quality of Service (QoS)
NOTE: The service-policy commands are not allowed on a port channel.
The service-policy input policy-map-name command and the
service-class dynamic dot1p command are not allowed simultaneously
on an interface.
— creates an input policy map.
Enter the name for the policy map in character format (32
characters maximum). You can identify an existing policy
map or name one that does not yet exist.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
— creates an output policy map.
1367