Reload - Dell Z9500 Reference Manual

Reply to request 5 from 172.31.1.87 0 ms
Dell#
Example (IPv6)
Dell#ping 100::1
Type Ctrl-C to abort.
Sending 5, 100-byte ICMP Echos to 100::1, timeout is 2 seconds:
!!!!!
Success rate is 100.0 percent (5/5), round-trip min/avg/max =
0/0/0 (ms)
Dell#

reload

Reboot the system.
Z9500
Syntax
reload [conditional nvram-cfg-change]
Parameters
conditional
nvram-cfg-
change
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
9.1(0.0)
8.3.19.0
8.3.11.1
7.6.1.0
7.5.1.0
E-Series
Usage If there is a change in the configuration, the system prompts you to save the new
Information configuration. Or you can save your running configuration with the copy
running-config command. Use the conditional parameter if any configuration
122
Reload if the condition is true. A configuration change to the
nvram requires a switch reload. To reload the switch, select
nvram-cfg-change.
Description
Introduced on the Z9500.
Added 'conditional' parameter.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S-Series.
Introduced on the C-Series.
Original command.
Control and Monitoring