Configure Flow Control; Configure Spanning Tree On Edge Ports; Save Configuration; Configure Additional Linecards - Dell C9000 series Configuration Manual

2.8

Configure flow control

Dell(conf-if-range-te-0/0-23,te-1/0-23)#flowcontrol rx on tx off
2.9

Configure spanning tree on edge ports

Dell(conf-if-range-te-0/0-23,te-1/0-23)#spanning-tree rstp edge-port
Dell(conf-if-range-te-0/0-23,te-1/0-23)#exit
Dell(conf)# protocol spanning-tree rstp
Dell(conf-rstp)#no disable
Dell(conf-rstp)#exit
Dell(conf)#interface range tengigabitethernet 0/0–23 , tengigabitethernet 1/0–23
Dell(conf-if-range-te-0/0-23,te-1/0-23)#no shutdown
Dell(conf-if-range-te-0/0-23,te-1/0-23)#exit
Dell(conf)#exit
2.10

Save configuration

Dell#copy running-config startup-config
Proceed to copy the file [confirm yes/no]: yes
2.11

Configure additional linecards

Repeat the commands from sections 2.2–2.10 to configure additional linecards.
Note: The preceding procedure places all switch ports in the default VLAN. If you prefer to place ports in
a non-default VLAN, refer to the documentation for your switch.
2.12

Save configuration and reload

Dell#copy running-config startup-config
Proceed to copy the file [confirm yes/no]: yes
Dell#reload
8 SCG2011 Dell Networking C9000 Series Switch Configuration Guide for Dell SC Series SANs