Honda 2004 Odyssey Service Manual page 472

6. Check for continuity between ABS/TCS control unit
16P connector terminal No. 1 and PCM connector
terminal D3.
PCM CONNECTOR D (17P)
ABS/TCS CONTROL UNIT
16P CONNECTOR
FPTDR
(PNK/BLK)
Wire side of female terminals
Is there continuity?
YES Go to step 7.
NO Repair open in the wire between the ABS/TCS
control unit and the PCM (D3).
7. Reconnect PCM connector D (17P).
8. Connect PCM connector terminals D3 and A30 with
a jumper wire.
PCM CONNECTORS
A (31P)
JUMPER WIRE
D (17P)
Wire side of female terminals
9. Reset the PCM (see page 11-4).
10. Start the engine, and wait 60 seconds.
Is DT C P167 6 indicated?
YES Substitute a known-good ABS/TCS control
unit and recheck. If the symptom/indication goes
away, replace the original ABS/TCS control unit.
NO Substitute a known-good PCM and recheck
(see page 11-5). If the symptom/indication goes
away, replace the original PCM.
FPTDR (PNK/BLK)
VCC2 (YEL/BLU)
FDTDR (PNK/BLK)
DTC P1676 '02-04 Models:
Line Failure
1. Reset the PCM (see page 11-4).
2. Start the engine, and wait 10 seconds.
Is DT C P167 6 indicated?
YES Go to step 3.
NO Intermittent failure system is OK at this time.
Check for poor connections or loose terminals at
the ABS/TCS control unit and the PCM.
3. Turn the ignition switch OFF.
4. Disconnect PCM connector E (20P) and the
ABS/TCS control unit 16P connector.
5. Check for continuity between body ground and
PCM connector terminal E16.
PCM CONNECTOR (20P)
Wire side of female terminals
Is there continuity?
YES Repair short in the wire between the ABS/
TCS control unit and the PCM (E16).
NO Go to step 6.
FPTDR Signal
FPTDR
(PNK/BLK)
(cont'd)
11-163 11-163