Table of Contents
Advertisement
INSTRUMENT PANEL GAUGES
AND CONTROLS
The information on the following pages
describes features installed or adapted to the dash
and driver's area by Winnebago Industries.
See your chassis operating guide for detailed
information on the instrument gauges, steering
column controls, brakes, and other chassis
original equipment.
HEADLIGHT BEAM CHANGE
AND TURN SIGNALS
Move multi-function lever upward for right
turn signal and downward for left turn signal.
Pull end of handle toward you to switch high
beam to low, or low beam to high.
WINDSHIELD WIPERS AND
WIPER DELAY
See your chassis operating guide for complete
operating information.
HAZARD WARNING FLASHER
The hazard warning flasher provides
additional safety when the vehicle must be
stopped on the side of the roadway and presents a
possible hazard to other motorists. When the
flasher is on, it serves as a warning to the other
drivers to approach and overtake your vehicle
with caution.
The front directional signals and the taillights
will flash intermittently when the flashers are in
operation. The hazard warning flashers will not
operate when the service brake pedal is
depressed. The turn signal will not operate when
the flashers are on. When it is necessary to leave
the vehicle, the flasher system will continue to
operate with the ignition key removed.
SECTION 5 – DASH / AUTO
CRUISE CONTROL
The electronic speed control (cruise) allows
you to maintain a steady speed and relieve
driving strain while traveling long distances.
See your chassis operator guide for complete
instructions and precautions on the cruise
control.
WARNING
Do not operate the cruise control on icy or
extremely wet roads, winding roads, in
heavy traffic, or in any other traffic
situation where a constant speed cannot
be maintained.
REARVIEW MONITOR SYSTEM
–Optional
If your motor home is equipped with this
optional system, refer to the Owner InfoCase for
specific instructions provided by manufacturer.
5-1
Advertisement
Table of Contents
