Setting And Adjustment Of Arms; Setting Mark Scan Mode And Numbers - GRAPHTEC FC8000 Series User Manual

5 -
2

Setting and Adjustment of ARMS

This section describes the necessary adjustment and settings to correctly scan the registration mark with
ARMS.

Setting MARK SCAN Mode and Numbers

P .5-6
P .5-9 Setting Shape (Pattern) of Registration Mark
P .5-11 Setting Registration Mark Size
Setting Mark Distance
P .5-12
Setting Distance Adjustment Between the Registration Mark
P .5-14
P .5-16 Setting Offset Between the Registration Mark and Cutting Origin Points
P .5-18 Adjusting the Sensor Level
Manually Adjusting the Sensor Level (Threshold Value)
P .5-19
Test the Registration Mark Sensor
P .5-21
Setting Speed of the Registration Mark Scan
P .5-23
P .5-24 Adjusting for the Registration Mark Scan Position
Supplement
In addition to above, also see about the paper-weight ("Setting Paper-Weight"
Setting MARK SCAN Mode and Numbers
Set the MARK SCAN mode to ARMS to perform automatic registration mark scan.
Supplement
There are "AXIS ALIGNMENT" and "OFF" in addition to "ARMS" in the MARK SCAN modes. T o turn "OFF", select "OFF" for the mode in
following procedures. See "Manual Position Adjust"
Set the numbers of registration marks when the MARK SCAN mode is set to ARMS. Select the POINTS from
2POINTS, 3POINTS, or 4POINTS. Position of the registration marks for each is as following.
2POINTS
P .7-21
P .6-1 for AXIS ALIGNMENT".
5-6
).