Table of Contents
Advertisement
Setting up notification by pager
1. Select the Cell/Pager Notification tab.
2. Select the Enable pager notification check box.
3. Enter the Pager number. Enter the number as you would normally dial it (i.e. without the
hunt group number). You can enter digits 0–9, space, dash, comma, # and *. A comma
pauses dialing for two seconds.
4. Enter the Numeric message that will appear on the user's pager.
Setting up the notification options
1. Click Configure Notification Options. The Configure Notification Options
window appears.
2. Select the hunt group the TalkSwitch system will use to phone or page the user.
3. Select the number of times the TalkSwitch system will ring the number before aborting each
attempt, ranging from 1 time to 10 times.
4. Select the number of additional attempts the TalkSwitch system should make, ranging from
never to 10 times.
5. Select the interval between attempts, ranging from 1 minute to 60 minutes.
6. Select the modes when the TalkSwitch system will perform notification. Choices include
Mode 1, Mode 2, Holiday Mode and All Modes.
Setting up message waiting light activation
If a local extension has a new message in its voice mailbox, the TalkSwitch system activates
notification on that extension, by default. The user hears a stutter dial tone when they pick up
the handset (not applicable to the TS-850i). If the extension supports an FSK message waiting
indicator (not applicable to IP phones), the message waiting light flashes. The TS-80, TS-200,
TS-400 and TS-600 extensions support a message waiting counter. The display on the extension
shows the number of new messages stored in the mailbox(es) associated with that extension.
You can also have the TalkSwitch system activate notification on a local extension if a message
is received in any other local extension, remote extension, or general mailbox.
T A L K S W I T C H C O N F I G U R A T I O N
80
Advertisement
Table of Contents
Troubleshooting
