Talkswitch CT.TS005.003904 User Manual page 276

Important Notices
Call Redirection & Service Provider Billing Advisory
Use of the automatic route selection, toll restriction and Call Detail Recording features does
not imply any guarantee whatsoever by regulatory authorities, your telephone service
provider(s), TalkSwitch or its distributors and resellers, with regard to the accuracy of these
features and that the use of such a features may not be considered by a telephone company
in any disputes which may arise regarding the accuracy of any subscriber's
telephone account.
CE Compliance
The product models listed below comply with the essential requirements of the European "Radio
and Telecom Terminal Equipment" (R&TTE) directive 1999/5/EC, and are for connection to
regular telephone lines (PSTN).This equipment has been tested and found to comply with the
following standards:
EN55022:1998 + amendment A1:2000 + amendment A2:2003, Class B
EN55024:1998 + amendment A1:2001 + amendment A2:2003
EN60950–1:2001, first edition
EN61000–3-2:2000
EN61000–3-3:1995+ amendment A1:2001
CISPR22:1997 + amendment A1:2000 + amendment A2:2002
This equipment is marked with the CE symbol,
indicating compliance with CE standards.
For Declaration of Conformity please contact local distributor or visit
http://global.talkswitch.com and select the required country.
FCC and IC Warnings
This equipment complies with ACTA TIA/EIA/IS-968A and Part 68 of the Federal
Communications Commission (FCC) rules in the United States. It also complies with regulations
RSS210 and CS-03 of Industry Canada and Science Canada. This equipment also complies with
Part 15 of the FCC Rules, as well as ICES003 of Industry Canada. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired
operation of the device.
FCC Part 15
This equipment has been tested and found to comply with the limits for a "CLASS B" Digital
Device pursuant to Part 15 of the FCC rules. These limits are designed to provide a reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy, and if not installed and used in accordance with
these instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
S A F E T Y A N D R E G U L A T O R Y I N F O R M A T I O N 257