If Registration Does Not Work; Adding Talkswitch Ts-850I Ip Phones; Installing The Base - Talkswitch CT.TS005.003904 User Manual

If registration does not work

If the IP phone is not successfully registered and configured, perform the following steps. On
the phone:
1. Press the Options key.
2. Use the cursor keys to navigate to the Phone Status menu, and then press Enter or Show.
3. Use the cursor keys to navigate to the Restore Defaults menu, and then press Enter
or Show.
4. Enter the password. By default this is 22222. When the TalkSwitch unit configures the
phone, it changes the password to 23646 (which spells "admin" on the telephone keypad).
5. Use the cursor keys to navigate to the Factory Defaults menu, and then press Enter
or Show.
6. Select All Defaults, and then press Enter or Show.
7. If setting up an external IP extension, follow the steps in Programming the TalkSwitch IP
phone as an external IP extension on page 89 after the phone reboots.
8. Contact your reseller or TalkSwitch Customer Support if registration is still unsuccessful.
For more information, refer to the Troubleshooting section in your phone user guide. Contact
your reseller or TalkSwitch Customer Support if you require further assistance with special ports
or network settings.

ADDING TALKSWITCH TS-850i IP PHONES

Installing the base

1. Place the base near a wired Ethernet router, either
on a tabletop or mounted on a wall. Avoid placing
the base in a location with a lot of metal, or near
devices that cause interference.
2. Connect the Ethernet cable from the WAN port on
the base to a LAN port on your router or Ethernet
switch. The TalkSwitch unit must be connected to
the same LAN.
3. Optionally connect the telephone cable from the
Line port on the base to the telephone wall socket.
This will allow you to use the TS-850i with a
traditional phone line.
T A L K S W I T C H C O N F I G U R A T I O N
Base / WAN
Router / LAN
Base
Phone socket
90