Using An Ip Extension; Making Calls; Placing An Intercom Call; Overhead Paging - Talkswitch CT.TS005.003904 User Manual

USING AN IP EXTENSION

This section describes how to use a third party IP phone with the TalkSwitch system. You can
also use these procedures with the TalkSwitch TS-9112i, TS-9133i and TS-480i phones. However,
these phones have additional keys that make it easier to access the functions. See Using
programmable keys with TalkSwitch IP phones on page 201, and refer to the guide supplied with
your TalkSwitch phone.

Making calls

Placing an intercom call

An intercom call is a call from a local extension to another local extension, remote extension or
ring group.
1. Dial the extension number.
If the Intercom calls follow cascade settings check box is selected in the configuration, an
intercom call will follow the call cascade of the dialed extension. Otherwise the intercom call
will ring continuously.
The dialed extension rings as follows:
• A local extension uses two short rings to identify the intercom call. IP phones supported by
TalkSwitch can identify intercom calls this way.
• A remote extension rings normally.
• A ring group uses the ring pattern selected in the configuration. The ring group uses the
same ring pattern for intercom calls and outside calls.

Overhead paging

Overhead paging is a call from a local extension through the optional PA amplifier connected to
the TalkSwitch unit.
1. Dial *0.

Two-way paging

Two-way paging is a call from a local extension to another local extension that activates the
speakerphone of the dialed extension. The user at the dialed extension can reply through the
speakerphone. You can perform two-way paging from a local extension to a TalkSwitch analog
phone (TS-200, TS-400 or TS-600), or a TalkSwitch IP phone (TS-9112i, TS-9133i or TS-480i).
1. Dial *84.
2. Dial the extension number.

One-way group paging

One-way group paging is a call from a local extension to another local extension or to a ring
group that activates the speakerphones of the dialed extensions. The users at the dialed
extensions cannot reply through the speakerphone. You can perform one-way group paging from
a local extension to a TalkSwitch analog phone (TS-200, TS-400 or TS-600).
1. Dial *85.
2. Dial the extension or ring group number.
U S I N G T A L K S W I T C H 196