Installing The Handset Charger; Installing The Batteries - Talkswitch CT.TS005.003904 User Manual

4. Connect the power adapter from the power outlet
to the power supply connector. Use a continuous
power outlet without a switch, which provides
uninterrupted power. We recommend using an AC
surge arrester in the power outlet. This is to avoid
damage to the equipment caused by lightning and
other electrical surges.
Only use the power supply included with the
product. Using an unauthorized power supply will
invalidate the product warranty and may damage
the telephone.

Installing the handset charger

1. Place the handset charger within the signal range of the base. The handset has an indoor
signal range of up to 150 feet (50 meters) from the base. Concrete and metal objects might
affect the signal range.
2. Connect the power adapter from the power outlet to the
power supply connector. Use a continuous power outlet
without a switch, which provides uninterrupted power.
We recommend using an AC surge arrester in the power
outlet. This is to avoid damage to the equipment caused
by lightning and other electrical surges.
Only use the power supply included with the product.
Using an unauthorized power supply will invalidate the
product warranty and may damage the telephone.

Installing the batteries

Use only approved AA Nickel Metal Hydride (Ni-MH) rechargeable batteries (1800+ mAh 1.2V).
Never use other batteries or conventional alkaline batteries.
1. Push in and down on the two
holes in the back of the handset
to release the battery cover.
2. Insert the batteries into the
handset, making sure that their
plus and minus ends are
oriented correctly.
3. Slide the battery cover shut.
T A L K S W I T C H C O N F I G U R A T I O N
Base
AC 110/220 V
91