Advanced Voip Configuration; Saving Settings To Talkswitch; Verifying The Talkswitch Voip Network; Service Provider Voip Network - Talkswitch CT.TS005.003904 User Manual

ADVANCED VOIP CONFIGURATION

Optionally, perform advanced VoIP configuration.
1. The default preferred codec is G.729. You can select the Preferred codec for the TalkSwitch
profile. All locations must use the same codec. See Setting codec options on page 233.
2. VoIP calls use extension names for caller ID by default. You can set the source for VoIP caller
ID at each location. The same setting will be used by the TalkSwitch profile and all service
provider profiles. See Setting up caller ID on page 236.
3. All VoIP lines are shared by default. You can reserve VoIP lines for the TalkSwitch profile at
each location. See Reserving VoIP lines on page 236.

SAVING SETTINGS TO TALKSWITCH

To transfer settings from your computer to the TalkSwitch system, choose File > Save. A window
appears indicating the configuration is being sent.

VERIFYING THE TALKSWITCH VOIP NETWORK

If you are configuring the TalkSwitch profile for the SIP server, the window enables the View
Registrar Entries button. Clicking the button shows the Registrar Entries window with a list
of VoIP numbers, their IP addresses and port numbers, and the number of seconds until their
registrations with the SIP server will expire.
1. Select the VoIP Configuration page.
2. Select Profile TS, and then click View Registrar Entries. The Registrar Entries
window appears.

SERVICE PROVIDER VOIP NETWORK

Using a service provider VoIP network requires at least one VoIP-enabled TalkSwitch unit. The
service provider acts as the SIP server. The service provider assigns the VoIP numbers and VoIP
configuration parameters.
V O I P I N F O R M A T I O N 230