Configuring The Router Manually - Talkswitch CT.TS005.003904 User Manual

2. To access the router configuration:
a) Click the link containing the IP address of the gateway. The default browser starts, and
prompts you for the router's user name and password.
b) Enter the router's user name and password. The browser shows a setup screen.
c) Navigate to the screen used to set up port forwarding. See your router documentation.
d) Set up port forwarding using the information from the Manual Port Mapping window.
See your router documentation for instructions on how to map ports. For information on
configuring routers and mapping ports, visit http://www.portforward.com/english/
routers/port_forwarding/routerindex.htm.
3. To check the status of each port through the firewall, click Check Firewall. The Test
Firewall window appears.
4. Select the services you want to check.
5. Click Test Ports. The system will check the ports of the selected services.

Configuring the router manually

If you cannot access the router configuration through the IP Configuration page, configure the
router manually.
1. Open the router configuration and navigate to the screen used to set up port forwarding.
See your router documentation.
2. Map port 5060 (Type: UDP) to the TalkSwitch unit acting as local proxy. Port 5060 is the
default port for forwarding SIP signaling data to the TalkSwitch system.
If required, you can map a different port. In this case, enter the port in the SIP signalling
port box of the VoIP Settings window.
3. Map the following ports (Type: UDP) to the TalkSwitch units. These RTP ports forward voice
traffic to the TalkSwitch system by default.
VoIP Lines/Unit
4
8
T A L K S W I T C H C O N F I G U R A T I O N
Unit 1 Unit 2
6000–6006 6010–6016
6100–6114 6200–6214
Unit 3 Unit 4
6020–6026 6030–6036
6300–6314 6400–6414
37