Setting Up A Service Provider Profile - Talkswitch CT.TS005.003904 User Manual

For example, the following illustration shows a service provider VoIP network.
Figure 21: Service provider VoIP network
To reach an outside party, the user dials the hunt group number associated with the service
provider profile, and then dials the phone number. The TalkSwitch unit routes the call over the
Internet to the service provider. If the outside party doesn't use the same service provider, they
are connected over the standard telephone network. If the outside party does use the same
service provider, they are connected over the Internet.
To reach a local extension, an outside party dials the VoIP number that was assigned to the
TalkSwitch system by the service provider. The call is routed through the telephone network to
the service provider. The service provider routes the call over the Internet to the TalkSwitch
system, which directs the call to the local extension.
Before proceeding, ensure you have:
• Connected the TalkSwitch system at each location to a network (page 218).
• Configured local IP addresses (page 219), and public IP addresses if required.
• Configured the router (page 222).

SETTING UP A SERVICE PROVIDER PROFILE

If you are using a TalkSwitch-certified VoIP service provider, visit the support section at http://
global.talkswitch.com to access the service configuration guide for your VoIP service provider.
Otherwise use the procedures in this section.
A service provider profile contains the registration details for connecting to the service
provider's SIP server.
1. Start the TalkSwitch management software.
2. Select the VoIP Configuration page.
V O I P I N F O R M A T I O N 231