Chapter 28 Monitoring Service Manager; Setting A Baseline For Http Local Server Statistics - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

Chapter 28
Monitoring Service Manager

Setting a Baseline for HTTP Local Server Statistics

This chapter describes how to monitor the Service Manager application. This chapter
discusses the following topics:
Setting a Baseline for HTTP Local Server Statistics on page 701
Monitoring the Connections to the HTTP Local Server on page 702
Monitoring the Configuration of the HTTP Local Server on page 702
Monitoring Statistics for Connections to the HTTP Local Server on page 703
Monitoring Profiles for the HTTP Local Server on page 704
Monitoring the Default Interval for Interim Accounting of Services on page 705
Monitoring the Status of the Service Manager License on page 706
Monitoring Profiles for Service Manager on page 706
Monitoring IPv4 and IPv6 Interfaces for Service Manager on page 707
Monitoring Service Definitions on page 717
Monitoring Service Session Profiles on page 718
Monitoring Active Owner Sessions with Service Manager on page 719
Monitoring Active Subscriber Sessions with Service Manager on page 721
Monitoring the Number of Active Subscriber and Service Sessions with
Service Manager on page 724
You can set a baseline for HTTP server statistics.
The system implements the baseline by reading and storing the statistics at the time
the baseline is set and then subtracting this baseline whenever baseline-relative
statistics are retrieved.
To set a baseline:
Include the baseline ip http command at the User Exec or Privilege Exec level:
host1#baseline ip http
There is no no version.
Setting a Baseline for HTTP Local Server Statistics
701