Figure 23: Subscriber Interfaces Using A Source Address To Demultiplex - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual
For e series broadband services routers - broadband access configuration
Hide thumbs
Also See for JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010:
- Configuration manual (712 pages)
Table of Contents
Advertisement
JUNOSe 11.0.x Broadband Access Configuration Guide
Figure 23: Subscriber Interfaces Using a Source Address to Demultiplex Traffic
To configure the static subscriber interfaces shown in Figure 23 on page 612, perform
the following steps:
1.
2.
612
Configuring Static Subscriber Interfaces
E Series router
Configure a primary IP interface on a supported layer 2 interface.
a. Create a layer 2 interface.
host1(config)#interface fastEthernet 4/1
b. Create a primary IP interface.
host1(config-if)#ip address 10.1.1.1 255.255.255.0
c.
Exit Interface Configuration mode.
host1(config-if)#exit
Configure subscriber interface IP1.
a. Create the shared IP interface.
host1(config)#virtual-router vra
Proceed with new virtual-router creation? [confirm] yes
host1:vra(config)#interface ip ip1
Advertisement
Table of Contents
Troubleshooting
