Monitoring Virtual Router Configuration; Table 61: Show Cac Interface Output Fields - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BGP AND MPLS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

JunosE 11.3.x BGP and MPLS Configuration Guide
Meaning
Related
Documentation

Monitoring Virtual Router Configuration

Purpose
Action
328
current total available bw 10 kbps
MPLS TE flooding threshold:
up 15 30 45 60 75 80 85 90 95 96 97 98 99 100
down 100 99 98 97 96 95 90 85 80 75 60 45 30 15
MPLS TE administrative weight 0
MPLS TE attribute flags 0
Available BW at 8 priority levels:
0 10 kbps
1 10 kbps
2 10 kbps
3 10 kbps
4 10 kbps
5 10 kbps
6 10 kbps
7 10 kbps
Table 61 on page 328 lists the show cac interfacevc command output fields.

Table 61: show cac interface Output Fields

Field Name
bandwidth
IP/MPLS reserveable bw
current total available bw
MPLS TE flooding
threshold up/down
MPLS TE administrative
weight
MPLS TE attribute flags
Available BW at 8 priority
levels
show cac interface
Display the configuration of all virtual routers or a specific virtual router.
To display VR configuration:
Field Description
Maximum physical bandwidth in Kbps; line rate
Total bandwidth in Kbps that can be reserved for MPLS; includes
bandwidth that is already reserved as well as bandwidth not yet
reserved
Total bandwidth in Kbps that is available to be reserved
Absolute percentages of total reservable bandwidth that trigger
the flooding of the new bandwidth value throughout the network;
flooding is triggered when bandwidth increases past any of the up
threshold values and when bandwidth decreases past any of the
down threshold values
Weight assigned to the interface that supersedes a weight assigned
by the IGP
32-bit value that assigns the interface to a resource class and
enables a tunnel to discriminate among interfaces by matching
against tunnel affinity bits
Bandwidth in Kbps that is available at each priority level in the range
0–7
Copyright © 2010, Juniper Networks, Inc.