Using Aaa Default Tunnel Parameters To Configure The Transmit Connect Speed Calculation Method - Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual

JunosE 11.2.x Broadband Access Configuration Guide
Using AAA Default Tunnel Parameters to Configure the Transmit Connect Speed Calculation
Method
396
For more information about how to map a domain to an L2TP tunnel from Tunnel
Group Tunnel Configuration mode, see "Mapping a User Domain Name to an L2TP
Tunnel Overview" on page 351.
From Tunnel Group Tunnel Configuration mode, configure the calculation method
2.
for the transmit connect speed of the subscriber's access interface.
host1(config-tunnel-group-tunnel)#tx-connect-speed-method qos
(Optional) Use the show aaa tunnel-group command to verify configuration of the
3.
transmit connect speed calculation method.
host1(config-tunnel-group-tunnel)#run show aaa tunnel-group
Tunnel Group: boston
Tunnel Tunnel
Tag Peer
------ ------
3 <null>
Tunnel
Tunnel Server
Tag Name
------ ------
3 <null>
Tunnel
Tunnel Failover
Tag Resync
------ --------
3 <null>
You can configure the transmit connect speed calculation method as a default AAA
tunnel parameter by using the aaa tunnel tx-connect-speed-method command from
Global Configuration mode. This command applies the specified calculation method to
all tunneled L2TP sessions associated with a particular virtual router, and thereby
alleviates the need for you to configure the transmit connect speed calculation method
for each individual subscriber.
Configuring the calculation method as a default AAA tunnel parameter for a virtual router
has lower precedence than using AAA domain maps, AAA tunnel groups, or RADIUS to
configure the transmit connect speed calculation method. The router uses the calculation
method specified with the aaa tunnel tx-connect-speed-method command if the tunnel
attributes returned from an AAA domain map, an AAA tunnel group, or a RADIUS
authentication server do not include the transmit connect speed calculation method.
To configure the transmit connect speed calculation method for all tunneled L2TP
sessions associated with a particular virtual router:
Create the virtual router for which you want to configure the transmit connect speed
1.
calculation method.
host1(config)#virtual-router north
Tunnel Tunnel Tunnel
Source Type Medium
------ ------ ------
<null> l2tp ipv4
Tunnel
Tunnel Max
Preference Sessions
---------- --------
2000 0
Tunnel
Tunnel Tx
Switch Speed
Profile Method
------- ------
<null> qos
Tunnel
Tunnel Tunnel Client
Password Id
-------- ------ ------
<null> <null> <null>
Tunnel
Virtual
Tunnel RWS Router
-------------- -------
system chooses <null>
Copyright © 2010, Juniper Networks, Inc.
Name