JunosE 11.2.x Broadband Access Configuration Guide
radius include tunnel-client-auth-id
radius include tunnel-server-auth-id
radius include framed-interface-id
208
[90] Tunnel-Client-Auth-Id
Use the following command to manage the Tunnel-Client-Auth-Id RADIUS attribute.
radius include tunnel-client-auth-id
Use to include the Tunnel-Client-Auth-Id attribute in Access-Request, Acct-Start, or
Acct-Stop messages.
You can control inclusion of the Tunnel-Client-Auth-Id attribute by enabling or disabling
this command.
See radius include
Example
host1(config)#radius include tunnel-client-auth-id access-request disable
Use the no version to restore the default, enable.
[91] Tunnel-Server-Auth-Id
Use the following command to manage the Tunnel-Server-Auth-Id RADIUS attribute.
radius include tunnel-server-auth-id
Use to include the Tunnel-Server-Auth-Id attribute in Access-Request, Acct-Start, or
Acct-Stop messages.
You can control inclusion of the Tunnel-Server-Auth-Id attribute by enabling or disabling
this command.
See radius include
Example
host1(config)#radius include tunnel-server-auth-id acct-start enable
Use the no version to restore the default, enable.
[96] Framed-Interface-Id
Use the following command to manage the Framed-Interface-Id RADIUS attribute.
radius include framed-interface-id
Use to include the Framed-Interface-Id attribute in Access-Request, Acct-Start, or
Acct-Stop messages.
You can control inclusion of the Framed-Interface-Id attribute by enabling or disabling
this command.
Copyright © 2010, Juniper Networks, Inc.