[41] Acct-Delay-Time - Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual

radius remote-circuit-id-delimiter
Related Topics
Copyright © 2010, Juniper Networks, Inc.
By default, the router formats the PPPoE remote circuit ID to include only the
agent-circuit-id suboption.
You can use this command to configure the following nondefault formats for the PPPoE
remote circuit ID value:
Include either or both of the agent-circuit-id and agent-remote-id suboptions, with
or without the NAS-Identifier [32] RADIUS attribute
Append the agent-circuit-id suboption value to an interface specifier that is consistent
with the recommended format in the DSL Forum Technical Report
(TR)-101—Migration to Ethernet-Based DSL Aggregation (April 2006).
For more information about how to use this command, see the Using the PPPoE Remote
Circuit ID to Identify Subscribers and Configuring PPPoE Remote Circuit ID Capture
sections in JunosE Link Layer Configuration Guide.
See radius remote-circuit-id-format
Examples
host1(config)#radius remote-circuit-id-format nas-identifier agent-circuit-id
agent-remote-id
host1(config)#radius remote-circuit-id-format dsl-forum-1
Use the no version to restore the default format, agent-circuit-id.
Use to configure the delimiter character that the router uses to set off multiple
components in the format of the PPPoE remote circuit ID value captured from a DSLAM.
For information about how to use this command, see the Configuring PPPoE Remote
Circuit ID Capture section in JunosE Link Layer Configuration Guide.
See radius remote-circuit-id-delimiter
Example
host1(config)#radius remote-circuit-id-delimiter !
Use the no version to restore the default delimiter character, #.
Monitoring Override Settings of RADIUS IETF Attributes on page 297
Monitoring the NAS-Identifier RADIUS Attribute on page 299
Monitoring the Format of the Remote-Circuit-ID for RADIUS on page 299
Monitoring the Delimiter Character in the Remote-Circuit-ID for RADIUS on page 300

[41] Acct-Delay-Time

Use the following commands to manage and display information for the Acct-Delay-Timer
RADIUS attribute.
Chapter 3: Configuring RADIUS Attributes
197