[32] Nas-Identifier - Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual

radius calling-station-delimiter
radius include calling-station-id
radius override calling-station-id remote-circuit-id
Related Topics
Copyright © 2010, Juniper Networks, Inc.
Use to specify the Calling-Station-Id attribute's delimiter for DSL PPP users.
The delimiter is one special character you select to set off items in the
Calling-Station-Id's definition (for example, # or %).
See radius calling-station-delimiter
Example
host1(config)#radius calling-station-delimiter &
Use the no version to remove the delimiter.
Use to include the Calling-Station-Id attribute in Access-Request, Acct-Start, or
Acct-Stop messages.
You can control inclusion of the attribute by enabling or disabling this command.
See radius include
Example
host1(config)#radius include calling-station-id acct-start disable
Use the no version to restore the default, enable.
Use to configure RADIUS to override the standard use of the Calling-Station-Id attribute
and instead use the remote circuit ID transmitted from a DSLAM device.
See radius override calling-station-id remote-circuit-id
Example
host1(config)#radius override calling-station-id remote-circuit-id
Use the no version to restore the default Calling-Station-ID value, which is the telephone
number from which the call originated.
Monitoring Override Settings of RADIUS IETF Attributes on page 297
Monitoring the Calling-Station-Id RADIUS Attribute on page 299

[32] NAS-Identifier

Use the following commands to manage and display information for the NAS-Identifier
RADIUS attribute.
radius nas-identifier
radius include nas-identifier
radius override nas-info
Chapter 3: Configuring RADIUS Attributes
195