Framed-Ip-Address; Framed-Ip-Netmask - Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual

JunosE 11.2.x Broadband Access Configuration Guide
radius pppoe nas-port-format unique
radius vlan nas-port-format stacked
Related Topics
radius include framed-ip-addr
188
Use to set the NAS-Port attribute to a unique value for subscribers on PPPoE interface.
This unique value is derived from the subscriber's profileHandle.
See radius pppoe nas-port-format unique
Example
host1(config)#radius pppoe nas-port-format unique
Use the no version to return to the default, in which the value is determined by the
interface.
Use to include the S-VLAN ID, in addition to the VLAN ID, in the NAS-Port attribute for
subscribers on Ethernet interfaces.
The VLAN ID is always included whether the S-VLAN ID inclusion feature is enabled
or disabled.
The radius pppoe nas-port-format unique command overrides this command.
See radius vlan nas-port-format stacked
Example
host1(config)#radius vlan nas-port-format stacked
Use the no version to return to the default, in which the S-VLAN ID is not included.
Monitoring the NAS-Port-Format RADIUS Attribute on page 298

[8] Framed-IP-Address

Use the following command to manage the Framed-IP-Address RADIUS attribute.
radius include framed-ip-addr
Use to include the Framed-IP-Address attribute in Acct-Start and Acct-Stop messages.
You can control inclusion of the attribute by enabling or disabling this command.
For RADIUS to include this attribute, an IP address must be assigned to the subscriber.
See radius include
Example
host1(config)#radius include framed-ip-addr acct-start enable
Use the no version to restore the default, enable.

[9] Framed-Ip-Netmask

Use the following commands to manage the Framed-IP-Netmask RADIUS attribute.
Copyright © 2010, Juniper Networks, Inc.