Tunnel Accounting Messages; Table 41: Aaa Accounting Tunnel Message Radius Attributes - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

Table 40: AAA Accounting Message Juniper Network (Vendor ID 4874) VSAs Supported (continued)
Attribute
Number Attribute Name
[26-152] Ipv6-Acct-Output-Octets
(See Note 2.)
[26-153] Ipv6-Acct-Input-Packets
(See Note 2.)
[26-154] Ipv6-Acct-Output-Packets
(See Note 2.)
[26-155] Ipv6-Acct-Input-Gigawords
(See Note 2.)
[26-156] Ipv6-Acct-Output-Gigawords
(See Note 2.)

Tunnel Accounting Messages

Table 41 on page 181 lists RADIUS attributes supported by the following tunnel-related
accounting messages:
Table 41: AAA Accounting Tunnel Message RADIUS Attributes Supported
Attribute
Number Attribute Name
[1] User-Name
[4] NAS-IP-Address
[26-51] Disconnect-Cause
[32] NAS-Identifier
[40] Acct-Status-Type
[41] Acct-Delay-Time
[44] Acct-Session-Id
[46] Acct-Session-Time
Acct-Start Acct-Stop
–
–
–
–
–
Acct-Tunnel-Start
Acct-Tunnel-Stop
Acct-Tunnel-Reject
Acct-Tunnel-Link-Start
Acct-Tunnel-Link-Stop
Acct-Tunnel-Link-Reject
Acct-Tunnel- Acct-Tunnel-
Start Stop
– –
– –
–
Chapter 3: Configuring RADIUS Attributes
Interim-Acct Acct-On
–
–
–
–
–
Acct-Tunnel- Acct-Tunnel- Acct-Tunnel-
Reject Link-Start Link-Stop
–
– –
– –
Subscriber AAA Accounting Messages
Partition- Partition-
Acct-Off Accounting- O n Accounting-Off
– – –
– – –
– – –
– – –
– – –
Acct-Tunnel-
Link-Reject
–
–
–
181