JUNOSe 11.0.x Broadband Access Configuration Guide
Setting Baselines for Remote Access
You can set baseline statistics using the baseline commands. The router implements
the baseline by reading and storing the statistics at the time the baseline is set and
then subtracting this baseline when you retrieve baseline-relative statistics.
110
Setting Baselines for Remote Access
Monitoring Configuration Information for AAA Local Authentication on page 129
Monitoring AAA Server Attributes on page 130
Monitoring the COPS Layer Over SRC Connection on page 132
Monitoring Statistics About the COPS Layer on page 134
Monitoring Local Address Pool Aliases on page 136
Monitoring Local Address Pools on page 136
Monitoring Local Address Pool Statistics on page 138
Monitoring Shared Local Address Pools on page 138
Monitoring the Routing Table on page 139
Monitoring the B-RAS License on page 140
Monitoring the RADIUS Server Algorithm on page 140
Monitoring RADIUS Override Settings on page 140
Monitoring the RADIUS Rollover Configuration on page 141
Monitoring RADIUS Server Information on page 141
Monitoring RADIUS Services Statistics on page 143
Monitoring RADIUS SNMP Traps on page 146
Monitoring RADIUS Accounting for L2TP Tunnels on page 147
Monitoring RADIUS UDP Checksums on page 147
Monitoring RADIUS Server IP Addresses on page 147
Monitoring the RADIUS Attribute Used for IPv6 Neighbor Discovery Router
Advertisements on page 148
Monitoring the RADIUS Attribute Used for DHCPv6 Prefix Delegation on page 148
Monitoring SRC Client Connection Status on page 148
Monitoring SRC Client Connection Statistics on page 150
Monitoring the SRC Client Version Number on page 152
Monitoring Subscriber Information on page 152
Monitoring Application Terminate Reason Mappings on page 157
Monitoring IPv6 Local Pools for DHCP Prefix Delegation By All Configured
Pools on page 159
Monitoring IPv6 Local Pools for DHCP Prefix Delegation By Pool Name on page 160
Monitoring IPv6 Local Pool Statistics for DHCP Prefix Delegation on page 161