Scanlab RTC 5 PC Interface Board Installation And Operation Manual page 621

343 load_stretch_table
366 micro_vector_abs
micro_vector_rel
367 micro_vector_abs_3d
micro_vector_rel_3d
380 park_position command,
park_return command
400 select_cor_table
select_cor_table_list
416 set_delay_mode_list
418 set_encoder_speed
set_encoder_speed_ctrl
424 set_fly_2d command
440 set_laser_control
449 set_matrix command
463 set_offset command,
set_offset_xyz command
468 set_pixel_line_3d
485 set_softstart_level_list
487 set_softstart_mode_list
493 set_trigger command
497 set_trigger4 command
542 timed_para_jump_abs_3d,
timed_para_jump_rel_3d,
timed_para_mark_abs_3d,
timed_para_mark_rel_3d
commands
554 wait_for_encoder_in_range
command
®
RTC 5 PC Interface Board
Rev. 1.9 e
18 Revision History
command Added (with version DLL 536, OUT 536)
command, Changed (version DLL 536, OUT 536): LasOn, LasOff < 2
command
command, Added (version DLL 536, OUT 536)
command
Added (version DLL 536, OUT 536)
command, Changed (with version DLL 533, OUT 534): value range of
command parameters
command Added (with version DLL 536, OUT 536)
command, Changed (with version DLL 536, OUT 536):
command EncoderNo = 2 and 3
Added (version DLL 536, OUT 536)
command Changed (with version DLL 536, OUT 536): bit#28
Changed (version DLL 536, OUT 536): HeadNo = 4
Changed (version DLL 536, OUT 536): HeadNo = 4
command Added (with version DLL 536, OUT 536)
command Added (with version DLL 536, OUT 536)
command Added (with version DLL 536, OUT 536)
Changed (with version DLL 536, OUT 536): Signal1,
Signal2 = 43 and 44
Added (with version DLL 536, OUT 536)
Corrected: These commands are list multi-commands
(instead of normal list commands)
Added (version DLL 536, OUT 536)
15
621