Scanlab RTC 5 PC Interface Board Installation And Operation Manual page 610

Page Name of section / command
553 verify_checksum
566 chapter 11 "Demo Programs"
567 chapter 12 "Troubleshooting"
Changes from revision 1.0 to revision 1.1
Page Name of section / command
30 chapter 2.7 "Notes For RTC
60 chapter 5.8 "Upgrading RTC
Boards"
94 "Ellipse Commands"
124 "Inverse Tables"
154 chapter 8.1.3 "Position Monitoring"
174 "Checking the Z-Axis Calibration"
186 chapter 8.7.5 "Deactivating
Processing-on-the-fly Corrections"
218 "Undelayed and Delayed Short List
Commands (as of Version OUT 515)"
233 arc_abs_3d command
235 arc_rel_3d command
263 get_error command
277 get_rtc_version command
287 get_transform command
291 get_value command
293 get_values command
312 laser_on_pulses_list
355 mark_ellipse_abs
356 mark_ellipse_rel
409 set_auto_laser_params
409 set_auto_laser_params_list
command
413 set_default_pixel
414 set_default_pixel_list
417 set_ellipse command
440 set_laser_control
481 set_sky_writing_para
483 set_sky_writing_para_list
command
524 stop_trigger command
®
RTC 5 PC Interface Board
Rev. 1.9 e
18 Revision History
Change
command Added
Added
Added
Change
®
4 Users" Extended
®
5 Added
Added
Added
Added
Revised
Added
Added
Added
Added
Added: Bit #10 (DSP version error)
Added: Bits #16...#23 (DSP version number)
Added
Added: new comments, code example
Added
command Added
command Added
command Added
command Added
Added
command Added
command Added
Added
command Added: Bit#5 for
command Added
Added
Added
laser_on_pulses_list
610