Scanlab RTC 5 PC Interface Board Installation And Operation Manual page 399

Undelayed select_char_set
Short
List Command
Function selects one of the available character sets (exclusively) for the execution of subsequent
mark_text
Call
select_char_set( No )
Parameter
No
Comments • The selection remains valid until another is encountered.
• The default value (after initialization) is No = 0.
• If No > 3, then the command will be replaced with a list_nop. The current character set
then remains valid
• A character set change within a
if a select_char_set is located within a (called) indexed character. The selection encoun-
tered there will then apply to all subsequent characters.
• If the selected character set is not (fully) defined, then missing characters will not be
marked (with
® ®
RTC 4 RTC 5 new command
References mark_text,
®
RTC 5 PC Interface Board
Rev. 1.9 e
10 Commands And Functions
and mark_text_abs commands.
number of the desired character set as an unsigned 32-bit value;
allowed range: [0 ... 3]
(get_last_error return code RTC5_PARAM_ERROR).
mark_text
mark_text or mark_text_abs).
mark_text_abs
or mark_text_abs command is only possible
399