Scanlab RTC 5 PC Interface Board Installation And Operation Manual page 581

Pin at MULTI Signal
connector
A1, A3, A5, A7, A9, DIGITAL OUT0...
A11, A13, A15, A17,
DIGITAL OUT15
A19, A21, A23, A25,
A27, A29, A31
LATCH OUT
A33
A2, A4, A6, A8, A10, DIGITAL IN0...
A12, A14, A16, A18,
DIGITAL IN15
A20, A22, A24, A26,
A28, A30, A32
A34 SYNC OUT
A36 BUSY OUT
VCC OUT
A35
DATA0...DATA6
B26, B28, B30, B32,
B34, B36, B38 (B40,
(DATA7)
B42)
(B42) (LATCH)
B44, B47, B48 LASER2, LASER1,
GND2
B3 - B10 ENCODER X1/2±
ENCODER Y1/2±
B11, B12 /STOP2, /START2
BUSY OUT
B13
®
RTC 5 PC Interface Board
Rev. 1.9 e
®
15 Appendix A: The RTC 5 PC/104-Plus Board
Signal description
buffered 16-bit digital output
(output signal level either 5 V or 3.3 V,
selectable via jumper JP1, see
LATCH signal for synchronization of data
transmission at the 16-bit digital output
(output signal level either 5 V or 3.3 V,
selectable via jumper JP1, see
16-bit digital input
SYNC signal for synchronization of data
transmission at the 16-bit digital input
(output signal level either 5 V or 3.3 V,
selectable via jumper JP1, see
BUSY status as BUSY OUT signal
(output signal level either 5 V or 3.3 V,
selectable via jumper JP1, see
output signal level selected via jumper JP1
(5 V or 3.3 V).
buffered 8-bit digital output port
(DATA7 optionally at B40, B42, dependent
on the JP2-JP8 jumper configuration, see
page 586)
LATCH signal for synchronization of data
transmission at the 8-bit digital output port
(optionally at B42, dependent on the JP2-
JP8 jumper configuration, see
The laser control signals LASER1 and LASER2
are referenced to GND2. If the
®
RTC 5 PC/104-Plus board is equipped with
optional optocouplers, then GND2 and the
laser output signals will be galvanically
decoupled from CPU GND. Otherwise,
GND2 are GND identical
encoder inputs
external stop signal,
external start signal
BUSY status as BUSY OUT signal
(5 V output signal level)
Connector on RTC
PC interface board
"EXTENSION 1
Connector", page 49
page 586).
"EXTENSION 1
Connector", page 49
page 586).
"EXTENSION 1
Connector", page 49
"EXTENSION 1
Connector", page 49
page 586).
"EXTENSION 1
Connector", page 49
page 586).
"EXTENSION 1
Connector", page 49
"EXTENSION 2
Connector", page 50
"EXTENSION 2
Connector", page 50
page 586)
"EXTENSION 2
Connector", page 50
"MARKING ON THE FLY
Connector", page 51
"MARKING ON THE FLY
Connector", page 51
"MARKING ON THE FLY
Connector", page 51
®
5
581