Scanlab RTC 5 PC Interface Board Installation And Operation Manual page 609

Page Name of section / command
275 get_mcbsp command
276 get_mcbsp_list command
276 get_overrun command
279 get_standby command
280 get_startstop_info
285 get_text_table_pointer
291 get_value command
296 goto_xy command
298 home_position command
298 home_position_xyz
326 load_auto_laser_control
load_correction_file
328
331 load_disk command
338 load_position_control
340 load_program_file
346 load_varpolydelay
347 load_z_table command
353 mark_date command
(mark_date_abs
412 set_control_mode
422 set_ext_start_delay
423 set_ext_start_delay_list
426 set_fly_rot command
(analogously for set_fly_rot_pos,
set_fly_x, set_fly_y,
and set_fly_y_pos)
443 set_laser_mode command
464 set_offset_xyz command
465 set_offset_xyz_list
493 set_trigger command
499 set_verify command
510 simulate_ext_start
511 simulate_ext_start_ctrl
523 stop_execution command
527 switch_ioport command
528 sync_slaves command
®
RTC 5 PC Interface Board
Rev. 1.9 e
18 Revision History
Change
Corrected: Return value is a signed 32-bit value
Added
Added
Added
command Added: beginning with firmware version 508, the firmware
returns the pulse length error bit (bit #17 or 25), when no
scan system is currently connected.
command Corrected: allowed index range
Added: current laser status returns even outside list
execution
Added: new comment (external stop signal)
Corrected: A home jump is also executed, if list execution is
stopped via
command Added
command Changed: return code 11
command Added: new error codes
Added: initialization via Name = 0
command Changed: return code 11
command Added: new error code
command Changed: return code 11
New: Error code 64 as return Value
Added: month and day-of-the-week can also be marked as
command, too) normal numerals (parameter Part = 6, 7).
command Added: Bit#10 for regular (periodic) external list starts
command Added: RTC
command Changed: Now a normal list command
Added: RTC
Changed: If unallowed parameter values are supplied, only
deactivates a Processing-on-the-fly correction previously
set_fly_x_pos activated via
the-fly correction.
Added: Laser mode 6
Added
command
Added: effective output value via parameter
Signal1/Signal2 = 20-23
Added: extended download verification
command Changed: Now a normal list command
Added: RTC
command Added
Corrected: A home jump is executed.
Added
Added
stop_execution or via an external stop signal.
®
4 compatibility mode for parameter Delay
®
4 compatibility mode for parameter Delay
set_fly_rot but not any other Processing-on-
®
4 compatibility mode for parameter Delay
609