Ctrl Command z_out
Support status
This RTC
®
®
RTC
4 RTC
5 For setting the Z value in a 3-axis scan system, the command
can be used (only together with an RTC
load_z_table(0.0, 1.0, 0.0), set_defocus(Z) has the same effect as z_out(Z) (also see
set_offset_xyz).
List Command z_out_list
Support status
This RTC
®
®
RTC
4 RTC
5 After load_z_table(0.0, 1.0, 0.0), set_defocus_list(Z) has the same effect as z_out_list(Z)
(also see set_offset_xyz_list).
®
RTC
5 PC Interface Board
Rev. 1.9 e
10 Commands And Functions
®
®
3/RTC
4 command is not supported by the RTC
®
®
3/RTC
4 command is not supported by the RTC
®
5.
set_defocus (see page 414)
®
5 with enabled 3D option). After
®
5.
565
Need help?
Do you have a question about the RTC 5 PC Interface Board and is the answer not in the manual?