Scanlab RTC 5 PC Interface Board Installation And Operation Manual page 620

Page Name of section / command
82 chapter 6.5.5 "Loops"
128 chapter 7.4.1 "Enabling, Activating
and Switching Laser Control Signals"
149 chapter 7.4.10 "Output
Synchronization"
158 "Notes on Loading Determined Jump
Delay Values" (chapter 8.1.5 "Jump
Mode")
170 chapter 8.5 "Using Several Different
Correction Tables"
176 chapter 8.6.5 "Enhanced 3D
Correction"
177 chapter 8.7 "Processing-on-the-fly
(Optional)"
218 "List Multi-Commands"
228 activate_fly_2d command,
activate_fly_xy command
264 get_fly_2d_offset
273 get_marking_info
285 get_table_para command
291 get_value command,
get_values command
294 get_waveform command
301 if_not_activated
305 init_fly_2d command
323 list_repeat command,
list_until command
328 load_correction_file
333 load_fly_2d_table
®
RTC 5 PC Interface Board
Rev. 1.9 e
18 Revision History
Change
Chapter added (version DLL 536, OUT 536)
Corrected: The laser output ports (LASERON, LASER1 and
LASER2) will also enter the (high impedance) tristate mode
if the laser control signals are subsequently disabled via a
command (also see disable_laser,
set_laser_control(bit#2 = 1)).
Notes changed (version RBF 527)
Corrected: the maximum value of the Length parameter for
jump delay tables is 1048576.0 (instead of 524288.0).
Changed (version DLL 533, OUT 534): up to 4 correction files
can be loaded
Chapter added (version DLL 536, OUT 536)
Changed (version DLL 536, OUT 536):
• New: section
• New:
the sections
Coordinate Transformations in the Virtual Image
• Revised:
• Extended:
on-the-fly Applications"
• New:
Added
Added (version DLL 536, OUT 536)
command Added (version DLL 536, OUT 536)
command Changed (version DLL 536, OUT 536): bit #9
Changed (with version DLL 533, OUT 534): value range of
TableNo
Changed (with version DLL 536, OUT 536): additional
selectable data signals (Signal = 43 and 44)
Changed (with version DLL 536, OUT 536):
Channel = 3 and 4
command Added (version DLL 536, OUT 536)
Added (version DLL 536, OUT 536)
Added (with version DLL 536, OUT 536)
command Changed (with version DLL 533, OUT 534): value range of No
(up to 4 correction files can be loaded)
command Added (version DLL 536, OUT 536)
pause_list
Overview
chapter 8.7.4 "Compensation of 2D Motions"
2D Encoder Compensation for XY Stages
chapter 8.7.6 "Virtual Image Field"
chapter 8.7.7 "Synchronization of Processing-
chapter 8.7.8 "Encoder Resets"
and
(incl.
and
Field)
620