Scanlab RTC 5 PC Interface Board Installation And Operation Manual page 433

Ctrl Command set_free_variable
Function sets a free variable to the desired value.
Call
set_free_variable( No, Value )
Parameters
No
Value
Comments • See chapter 6.9.1 "Free Variables", page
® ®
RTC 4 RTC 5 new command
Version info Available beginning with version DLL 531, OUT 532
References set_free_variable_list, get_free_variable,
Undelayed set_free_variable_list
Short
List Command
Function same as
Call
set_free_variable_list( No, Value )
Parameters
No
Value
Comments • See set_free_variable.
® ®
RTC 4 RTC 5 new command
Version info Available beginning with version DLL 531, OUT 532
References set_free_variable
®
RTC 5 PC Interface Board
Rev. 1.9 e
10 Commands And Functions
Number of the free variable to be set as an unsigned 32-bit value.
Allowed range: [0 ... 3]
Only the two least significant bits are evaluated.
Desired variable value as an unsigned 32-bit value.
Allowed range: [0 ... (2
set_free_variable (see above), but a list command
See set_free_variable.
See set_free_variable.
32 –
1)]
92.
set_trigger
433