Scanlab RTC 5 PC Interface Board Installation And Operation Manual page 473

Ctrl Command set_rtc4_mode
®
Function sets RTC
Call
set_rtc4_mode()
®
Comments • RTC
available so that user programs written for the RTC
®
RTC 5 (to a large extent) without needing to modify the programming code. However,
a prerequisite here is that the program can only contain RTC
exist with unchanged functionality as RTC
commands, when applicable, notes such changes in the "RTC
®
• RTC 5 mode is pre-defined as the default DLL operation mode and can also be specified
subsequently via
• The current DLL operation mode can be queried via
• The set_rtc4_mode is also available without explicit access rights to a particular board.
• set_rtc4_mode is not available as a multi-board command.
• This command's scope is not board-specific, but rather global to the DLL and all RTC
boards to which the application has access rights.
• The board-specific error variables LastError and AccError (see
87) are neither generated nor altered by set_rtc4_mode.
® ®
RTC 4 RTC 5 new command
References get_rtc_mode,
Ctrl Command set_rtc5_mode
®
Function sets RTC
Call
set_rtc5_mode()
Comments • set_rtc4_mode (page 473)
• The current DLL operation mode can be queried via
• The set_rtc5_mode command is also available without explicit access rights to a partic-
ular RTC
• set_rtc5_mode is not available as a multi-board command.
• This command's scope is not board-specific, but rather global to the DLL and all RTC
boards to which the application has access rights.
• The board-specific error variables LastError and AccError (see
87) are neither generated nor altered by set_rtc5_mode.
® ®
RTC 4 RTC 5 new command
References get_rtc_mode,
®
RTC 5 PC Interface Board
Rev. 1.9 e
10 Commands And Functions
4 compatibility mode as the current DLL operation mode
4 compatibility mode is an optional operation mode of the DLL. It has been made
set_rtc5_mode (page
set_rtc5_mode
5 mode as the current DLL operation mode (default setting)
sets the DLL operation mode to RTC
®
5 board.
set_rtc4_mode
®
4 can also be processed by the
®
4 commands that also
®
5 commands. This user manual's list of
®
4 RTC
473).
get_rtc_mode (page
"Error Handling", page
®
4 compatibility mode.
get_rtc_mode (page
"Error Handling", page
®
5" section.
277).
®
5
277).
®
5
473