Scanlab RTC 5 PC Interface Board Installation And Operation Manual page 453

Ctrl Command set_mcbsp_in
References set_mcbsp_in_list
Undelayed set_mcbsp_in_list
Short
List Command
Function identical with
Restriction If the Processing-on-the-fly option is not enabled, then the command terminates the
Processing-on-the-fly process (even though it couldn't have been activated).
Call
set_mcbsp_in_list( Mode, Scale )
Parameters
Mode
Scale
Comments • If Mode > 5, then set_mcbsp_in_list will be replaced by a
return code RTC5_PARAM_ERROR).
• See set_mcbsp_in.
® ®
RTC 4 RTC 5 new command
Version info Available beginning with version DLL 531, OUT 532
References set_mcbsp_in
®
RTC 5 PC Interface Board
Rev. 1.9 e
10 Commands And Functions
set_mcbsp_in (see above), but a list command
See set_mcbsp_in.
See set_mcbsp_in.
list_nop (get_last_error
453