Scanlab RTC 5 PC Interface Board Installation And Operation Manual page 477

Normal set_serial_step_list
List Command
Function sets the starting serial number and the increment size for the serial-number-set most
recently selected via
load_program_file).
Call
set_serial_step_list( No, Step )
Parameters
No
Step
Comments • During initialization, the starting serial number (for
is set to 0 and the increment size set to 1.
• If mark_serial
number incrementing was deactivated), then the increment size setting will have no
effect.
• If Step = 0, then incrementing will not occur, except in the case of markless marking
(see mark_serial
numbers by 1.
• For command usage, see
® ®
RTC 4 RTC 5 new command
Version info Available beginning with version DLL 537, OUT 537
References set_serial_step, select_serial_set_list, get_list_serial, mark_serial,
Ctrl Command set_sky_writing
Function activates or deactivates Sky Writing mode and sets the corresponding parameters
Call
set_sky_writing( Timelag, LaserOnShift )
Parameters
Timelag
LaserOnShift See set_sky_writing_para.
Comments • The command is identical to set_sky_writing_para(Timelag, LaserOnShift, Nprev,
Npost) with Nprev = approx. (0.15 · Timelag) and Npost = approx. (0.1 · Timelag).
• Also see information about
® ®
RTC 4 RTC 5 new command
References set_sky_writing_para,
®
RTC 5 PC Interface Board
Rev. 1.9 e
10 Commands And Functions
select_serial_set_list
Serial number as an unsigned 32-bit value; allowed range: [0 ... (2
Increment size as an unsigned 32-bit value;
allowed range: [0 ... 9999]; only the last 4 decimal digits are used.
or mark_serial_abs was called with Mode M
or mark_serial_abs: digits = 0), which always increments serial
chapter 7.5.2 "Marking Serial Numbers", page
See set_sky_writing_para.
set_sky_writing_para
set_sky_writing_list
(or for serial-number-set 0 after
mark_serial and mark_serial_abs)
= 1 (i.e. automatic serial-
2
mark_serial_abs
and "Sky Writing", page
32
–1)]
150.
113.
477