Scanlab RTC 5 PC Interface Board Installation And Operation Manual page 487

Variable set_softstart_mode_list
List Command
Function same as
Call
set_softstart_mode_list( Mode, Number, Delay )
Parameters See set_softstart_mode.
Comments • set_softstart_mode_list switches off the "laser active" laser control signals by
executing
• Otherwise this command is identical to the control command
see the comments there).
® ®
RTC 4 RTC 5 new command
Version info Available as of version DLL 536, OUT 536
References set_softstart_mode, set_softstart_level,
®
RTC 5 PC Interface Board
Rev. 1.9 e
10 Commands And Functions
set_softstart_mode (see above), but a list command
list_nop and waits until the LaserOff delay has expired.
set_softstart_mode
set_softstart_level_list
(also
487