Scanlab RTC 5 PC Interface Board Installation And Operation Manual page 502

Delayed Short set_wobbel
List Command
® ® ®
RTC 4 RTC 5 The RTC
coordinate system. For the RTC
used to define an ellipse-shaped movement (the frequency's sign determines the direction
of rotation) that follows the current direction of movement.
The image field coordinates for the X and Y axes are specified as 20-bit values; in RTC
compatibility mode they are specified as 16-bit values (as with the RTC
multiplies the specified value for the amplitudes Longitudinal and Transversal by 16 (the
permissible range of values is correspondingly reduced to [1 ... 8191]).
References set_mark_speed,
®
RTC 5 PC Interface Board
Rev. 1.9 e
10 Commands And Functions
4 only executed (elliptical) wobbel movements permanently referenced to the
®
5, the parameters Transversal and Longitudinal can be
set_wobbel_mode
®
4
® ®
4) and the RTC 5
502